3D MODEL DESCRIPTION
A clicker hidden inside a witch hat that lights up the cat's eyes when pressed. Satisfying to click, impossible to put down.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 02 Hours, 05 Minutes* (may vary according to your printer model)
Multiparts - 01 Hours, 55 Minutes* (may vary according to your printer model)
Multicolor - 08 Hours, 24 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 10 cm (Assembled Files)
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: “Multipart” files requires super glue.
You Will Need: Led 3V- 1x - Amazon - AliExpress - Mercado Livre
Clicker Switch - 1x - Amazon - AliExpress - Mercado Livre
Lithium Battery 1220 - 1x - Amazon - Aliexpress - Mercado Livre
3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.12 mm
- Recommended Layer Height: 0.12 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: Yes, (Manual Snug) only in “Hat” files.
- Build Plate Adhesion: Yes, (Brim Type) only in “Eyes” files.
- Others: In the “Eye” files, use 0% infill and only 1 wall.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!