3D MODEL DESCRIPTION
Tiny, round, and ready to roll. This little chick waddles forward with every push, and it is absolutely as cute as it sounds.
- This STL file is recommended for FDM Printers!
- 3D Printing Time:
- Monocolor - 02 Hours 21 Minutes* - 40 g of filament (may vary according to your printer model)
- Multicolor - 09 Hours 31 Minutes* - 144 g of filament (may vary according to your printer model and the amount of colors in your AMS, in this print we've used 04 colors)
- Multipart - 02 Hours 51 Minutes* - 42 g of filament (may vary according to your printer model)
- Approximately Height: 09 x 07 x 06 cm
*Note: Printing time and filament based on a Bambu Lab A1 printer, according to our tests.
ATTENTION: These files require super glue.
YOU WILL NEED:
2x Latex rubber band No. 8 Amazon - AliExpress - Mercado Livre
Note: Following the instructions above, you can use any elastic band of your choice if you have one at home.
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.42 mm
- First Layer Line Width: 0.5 mm / 125%
- Average Speed: 20 mm/s (First Layer) / 200–330 mm/s (All the other layers on Bambu Lab) | 20 mm/s (First Layer) / 25–50 mm/s (All the other layers, Ender like)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.16 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Grid)
- Needs Support: No.
- Build Plate Adhesion: Yes (auto brim).
- Others: *For the "Wheels" files, use "Spiral" mode on the top and bottom layers. *You can use "Concentric" mode for the remaining files. *For the "Paws" files, use TPU filament and a TPU profile.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
