3D MODEL DESCRIPTION
Built for endless worc. Holds your tools while you grind through the day.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 05 Hours 38 Minutes* (may vary according to your printer model)
Multipart - 05 Hours 43 Minutes* (may vary according to your printer model)
Multicolor - 01 Day 06 Hours* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 07 colors splitted in 3 print plates) - Approximately Height: 18 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
You Will Need: BIC Ballpoint Pen (You will only use the Pen Refill) - Mercado Livre | Amazon
Post-It 3x3’’ - Mercado Livre | Amazon | Aliexpress
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Grid)
- Needs Support: Yes, you’ll need to use on both Hands and the Body on monocolor and multicolor.
- Build Plate Adhesion: Yes, you’ll need to use Brim on the pen.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
