3D MODEL DESCRIPTION
Just hatched. Already in charge of the nest.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Egg Monocolor- 01 Hours 35 Minutes* (may vary according to your printer model)
Monocolor - 01 Hours 40 Minutes* (may vary according to your printer model)
Multicolor - 18 Hours 43 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 05 colors) - Approximately Height: 7 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
ATTENTION: Before starting to print the egg, you need to have the "dino" already printed.
ATTENTION: It's necessary to add a pause in the egg printing at a height of 55 mm to place the "dino" inside the egg. And, after placing the already printed "dino" inside the egg, it's necessary to resume printing.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.12 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Yes. Outer brim only.
- Others:
- Dino and Egg
- Top surface pattern: Concentric
- Base
- Top surface pattern: Monotonic
- Stitching position: Aligned. Disable smart scarf stitching application.
- Dino and Egg
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!