Stretch it Dual Controller Grip
3D MODEL DESCRIPTION
Stretch it, snap it, game on! This grip's got your controllers covered for those marathon gaming sessions.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 3 Hour 26 Minutes* (may vary according to you Approximately Height: 10 cm
*Note: Printing time based on a Bambu P1S printer, according to our tests.
*Notice: Some overhang will be visible. If your equipment is calibrated and properly adjusted, this condition will be minimal. We recommend using support only on the bridge below the controller, between the two grip handles. Using support in other areas of the model is at your discretion.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.16 mm
- Recommended Layer Height: 0.16 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: Yes.
- Build Plate Adhesion: No.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
