3D MODEL DESCRIPTION
A round snowman with snowflake details that let the LED light filter through, creating a soft glow all around. Simple, festive, and works in any holiday setup.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 02 Hours 43 Minutes* (may vary according to your printer model)
Multiparts - 03 Hours 22 Minutes* (may vary according to your printer model)
Multicolor - 13 Hours 23 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Filament consumption: Monocolor - 45.02 grams (may vary according to your printer model)
Multiparts - 53.53 grams (may vary according to your printer model)
Multicolor - 257.48 grams (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 12 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests. Filament consumption is an estimate and may vary depending on your settings. Time, considering one of the two available versions
ATTENTION: “Multipart” files requires super glue.
Will you need:
You may choose one of the types of candle LED described below. The choice is up to you, or it may depend on what is available in your area.
Candle LED 2032: Amazon - Aliexpress - Mercado Livre (the top part needs to be removed)
Candle LED LR41 / LR1130: Aliexpress - Mercado Livre (the top part needs to be removed)
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
WARNING: There are two models, one for each type of tea light candle chosen. The lids only fit their respective model, the lids for one type do not fit the other.
3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Brim, only in “nose” and “Hat Stripe multipart” files.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
