3D MODEL DESCRIPTION
Remember, big dogs eat, so just pup it up!!
- This STL file is recommended for FDM Printers!
- 3D Printing Time Based on Ender 3: 08 Hours, 38 Minutes (will vary accord to you printer model)
- Approximate Measurements: 15 x 10 x 7,5 cm
- ATTENTION! For this STL, You will need to measure the collar you will use on your pet, to apply these values to your slicing before printing the final piece.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
