3D MODEL DESCRIPTION
The future is here and it holds your phone for you. How awesome is that?
This model has a steady locking system, it's adjustable and you don't have to use any supports for printing! For instructions, check the assembly video.
Check the assembly instructions below:
Start with "Robot Claw Phone Holder_base".
Attach "Robot Claw Phone Holder_Lower_Arm_Long" on top of the base.
Next, insert "Robot Claw Phone Holder_Screw_3" between the two previous pieces.
Place "Robot Claw Phone Holder_Quick_Release_Clip_1" on top of "Robot Claw Phone Holder_Screw_3" and fold it until it applies pressure.
Attach "Robot Claw Phone Holder_Upper_Arm_Long" on top of "Robot Claw Phone Holder_Lower_Arm_Long" and secure them together using "Robot Claw Phone Holder_Screw_2".
Attach "Robot Claw Phone Holder_Quick_Release_Clip_2" and fold it until it applies pressure.
Attach "Robot Claw Phone Holder_Wrist" on top of "Robot Claw Phone Holder_Upper_Arm_Long" and secure both pieces using "Robot Claw Phone Holder_Screw_1".
Place "Robot Claw Phone Holder_Quick_Release_Clip_1" and fold it until it applies pressure.
Separately, attach "Robot Claw Phone Holder_Left_Finger" and "Robot Claw Phone Holder_Right_Finger" to the pins of "Robot Claw Phone Holder_Hand".
Next, place "Robot Claw Phone Holder_Middle_Finger" in the middle.
Then, attach "Robot Claw Phone Holder_Cover" and twist it until it locks.
Finally, attach this entire piece to "Robot Claw Phone Holder_Wrist".
Adjust the pressure and position using the clips. Adjust them as desired!
The smaller version follows the same assembly instructions, with the only change being the parts "Robot Claw Phone Holder_Lower_Arm" from "_Long" to "_Short" and "Robot Claw Phone Holder_Upper_Arm" from "_Long" to "_Short".
- This STL file is recommended for FDM Printers!
- 3D Printing Time: 1Day 23 Hours and 3 Minutes
- Approximately length: 39cm x 18cm x 18cm
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 60mm/s (All the other layers) / 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Skirt.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!