3D MODEL DESCRIPTION
Shining bright and always prepared, especially when you mix in new pieces of armor.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Crusader 01 - Monocolor - 02 Hours 04 Minutes* (may vary according to your printer model)
Multicolor - 11 Hours 03 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors)
Crusader 02 - Monocolor - 02 Hours 03 Minutes* (may vary according to your printer model)
Multicolor - 17 Hours 24 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 12,5 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
You Will Need: 8x Neodymium Magnets 5mm x 1mm - Mercado Livre | Aliexpress | Amazon
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
ATTENTION: “Multipart” files requires super glue.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Grid)
- Needs Support: No.
- Build Plate Adhesion: No.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
