3D MODEL DESCRIPTION
For all the rebel pets out there.
- This STL file is recommended for FDM Printers!
- 3D Printing Time Based on Ender 3: Large - 09 Hours, 03 Minutes (will vary accord to you printer model)
Small - 07 Hours, 23 Minutes (will vary accord to you printer model) - Approximate Measurements: Punk Hair - 6,5 x 16,5 cm
Large Collar Band - 05 x 02 x 02 cm
Small Collar Band - 02 x 01 x 01 cm
- ATTENTION! For this STL, You will need to measure the collar you will use on your pet, to apply these values to your slicing before printing the final piece.
- Use a colorful ribbon or elastic to secure the "punk hair" on your pet.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: Yes, (Grid) only “Collar Band” files (if your printer is not calibrated to do bridge mode)
- Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
