3D MODEL DESCRIPTION
This pig comes pre sliced. Pull out a piece when needed, place your drink down, and try not to think too hard about it.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 07 Hours, 42 Minutes * (may vary according to your printer model)
Multiparts - 09 Hours, 52 Minutes* (may vary according to your printer model)
Multicolor - 17 Hours, 40 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 11 cm
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: “Multipart” files requires super glue.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.20 mm
- Recommended Layer Height: 0.20 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Yes, (Brim) only on the highest parts of the table with low adhesion.
- Others: If you prefer, use “Concentric” top layer for a better finish.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
