3D MODEL DESCRIPTION
Your picks go everywhere you go. A compact vinyl-shaped case that clips to your keychain so you are never without one when inspiration hits.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 01 Hours 04 Minutes* (may vary according to your printer model)
Multiparts - 01 Hours 10 Minutes* (may vary according to your printer model)
Multicolor - 03 Hours 10 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 2 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
You Will Need: Neodymium Magnetic Size 6x3 - AliExpress - Amazon - Mercado Livre
Split Key Ring with Chain - AliExpress - Amazon - Mercado Livre
Ring Conector 12 mm - AliExpress - Amazon - Mercado Livre
ATTENTION: To insert the magnets, you need to add a pause during printing.
ATTENTION: “Multipart” files requires super glue.
NOTE: The first time you fit the blades, you will probably need to use force. This is because the walls may be close together; the model was designed this way to increase its lifespan and reduce wear and tear on the walls.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 3% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Yes. Outer brim only.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!