3D MODEL DESCRIPTION
Disclaimer: we do not recommend using it for pet orcas.
- This STL file is recommended for FDM Printers!
- 3D Printing Time Based on Ender 3: “Main House” files - 06 Days, 22 Hours, 45 Minutes (will vary accord to you printer model)
“Orca Pet House” files - 28 Hours, 10 Minutes (will vary accord to you printer model)
- Attention in this Assembly:To avoid wasting material in this model, you should print almost the entire "Main House", but first subtract 3x of the 12x "Joints", 1x of the 1x “Roof” from the "Main House" folder, then add and print the subtracted pieces that are in the “Orca Pet House” folder, so you will have a complete house and will not waste extra pieces.
- Approximate Measurements: 40 x 40 x 40 cm
- ATTENTION! For this stl, you will need super glue to join some pieces.
- NOTE: We do not recommend the use of SILK filaments for this piece. The piece contains fittings and joints, and the Silk filament does not have the necessary physical properties to ensure the required strength for the piece. The use of Silk-type filament is at your discretion.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
