3D MODEL DESCRIPTION
A wide-grinned creature that looks absolutely delighted about causing chaos. Pull its limbs and watch it flail with full enthusiasm.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 08 Hours 26 Minutes* (may vary according to your printer model)
Multiparts - 09 Hours 05 Minutes* (may vary according to your printer model)
Multicolor - 14 Hours 19 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 9 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.Time considering only one version, between the two available (keychain and figurine)
ATTENTION: Requires super glue.
You will need;
Split Key Ring with Chain: Amazon - Aliexpress - Mercado Livre
Ring Conector 12 mm: Amazon - Aliexpress - Mercado Livre
Magnets 5x2mm: Amazon - Aliexpress - Mercado Livre
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: Yes, normal (manual).
- Build Plate Adhesion: Brim, in the files; “Mouth multipart” , “Left eye multipart” and “Right multipart”.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!