3D MODEL DESCRIPTION
A simple way to display photos on the wall without frames or nails. It fits right into the modular system and keeps the look clean and intentional.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 01 Hours 31 Minutes* (may vary according to your printer model)
- Approximately Height: 1 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
Note: This model has a built-in magnet slot, and to insert it, a print pause must be scheduled at the corresponding layer.
Important: If your nozzle is metal, it may attract the magnet. A drop of super glue might be necessary.
You will need;
Neodymium Magnet 6x3mm (x4); Amazon - Aliexpress - Mercado Livre
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: No.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!