3D MODEL DESCRIPTION
Cuts in, lines it up, and goes for goal. Every move feels like a highlight.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 05 Hours 59 Minutes* (may vary according to your printer model)
Multicolor - 01 Day, 13 Hours 09 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 9 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
ATTENTION: For printing the “springs”, we recommend doing a filament test. Some colors tend to stiffen the “spring”.
Left Winger
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Grid)
- Needs Support: No.
- Build Plate Adhesion: Yes. Outer brim only.
- Others: To improve the finish and make the design more attractive, draw the stitching on the shirt and socks along the sides, mimicking real clothing.
Goal and Soccer Ball
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Grid)
- Needs Support: No.
- Build Plate Adhesion: Yes. Only on the "Pin" of the soccer ball.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!