3D MODEL DESCRIPTION
Stack a box, find a cat. Keep stacking, keep discovering. It is the kind of toy that turns a quiet afternoon into a full story without any instructions needed.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Base Monocolor - 02 Hours 35 Minutes* (may vary according to your printer model)
Monocolor - 05 Hours 57 Minutes* (may vary according to your printer model)
Multicolor - 16 Hours 40 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 5 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 3% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: No.
Cats
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 49 Minutes* (may vary according to your printer model)
Multicolor - 03 Hours 44 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 2 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
ATTENTION: To attach the “cats” to the “boxes”, requires super glue.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 3% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Yes. Brim Ear.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!