A classic jack-o’-lantern with an old-fashioned lantern twist. Carved, glowing, and ready to guard your Halloween night.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Multipart - 15 Hours, 31 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 04 colors)
- Approximately Height: 25 cm (assembled files)
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: This files requires super glue.
You Will Need: LED Candle: Mercado Livre - Amazon - Aliexpress
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.16 mm
- Recommended Layer Height: 0.16 mm
- Others: We use (Archimedean Chords) for finishing the top layers.
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid) and you will need to use (0%) infill only on light “Diffuser” file and remove its the bottom layer.
- Needs Support: No.
- Build Plate Adhesion: Yes. (Painted Brim) only in the smallest parts with low bed adhesion.
- Others: For small part use a 0.08 mm profile for better finishing.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!