Inkcantation - Pen & Sticky Notes Holder

3D MODEL DESCRIPTION
 

A spellbound book that keeps your writing tools exactly where you need them.

• This STL file is recommended for FDM Printers!
• 3D Printing Time : Monocolor - 07 Hours 38 Minutes*  (may vary according to your printer model)
                                Multipart - 08 Hours 29 Minutes*  (may vary according to your printer model)
                                Multicolor - 22 Hours 44 Minutes*  (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 05 colors splitted into 4 print plates)
• Approximately Height: 36 cm

*Note: Printing time based on a Bambu P1s printer, according to our tests. To mold the shape of the feather you will need a source of heat, it could be a warm water or a heat gun.

You Will Need: BIC Ballpoint Pen (You will only use the Pen Refill) - Mercado Livre | Amazon 
                          Post-It 3x3’’ - Mercado Livre | Amazon | Aliexpress           

Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)

• Line Width/ Nozzle: 0.4 mm
• First Layer Line Width: 0.48 mm / 120%
• Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
• Recommended Initial Layer Height:  0.2 mm
• Recommended Layer Height:  0.2 mm
• Recommended Perimeters/ Walls: 3.
• Recommended Infill (%): 5% (Grid)
• Needs Support: No.
• Build Plate Adhesion: Yes, you’ll need to use Brim on the pen.

The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.

Happy Printing!