3D MODEL DESCRIPTION
No need to be cold-blooded about love! These slithery soulmates are intertwined and inseparable, proving that opposites attract and coil together perfectly.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 47 Minutes 46 Seconds* (may vary according to you printer model)
Multipart - 49 Minutes 35 Seconds* (may vary according to you printer model)
Multicolor - 03 Hours 15 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors)
Monocolor Heart Rock - 51 Minutes 37 Seconds* (may vary according to you printer model) - Approximately Length: 9,8 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
ATTENTION: - “Multipart” files requires super glue.
- You’ll need to glue the cover over the magnet, if you wish.
You Will Need: 6x2 mm Neodymium Magnets - Mercado Livre | Aliexpress | Amazon
Split Key Ring with Chain - AliExpress - Amazon - Mercado Livre
Ring Conector 12 mm - AliExpress - Amazon - Mercado Livre
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 8% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
