3D MODEL DESCRIPTION
The full setup. Two pen holders, a keyholder, sticky note holder, shelf, and two hangers, your complete wall system for work, home, and everything in between.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 11 Hours, 56 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 02 colors)
- Approximately Height: 100 cm (assembled files)
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: Follow the instruction manual for correct assembly.This files requires super glue.
You will need: 02 x Neodymium Magnets (6 x 3 mm round) - Mercado Livre - Amazon - Aliexpress
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.20 mm
- Recommended Layer Height: 0.20 mm
- Others: We use (Archimedean Chords) for finishing the top layers.
- Recommended Perimeters/ Walls: 3 walls
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: Yes, (Painted Grid) only in “Male Joints” fit.
- Build Plate Adhesion: Yes. (Painted Brim) only in the smallest parts with low bed adhesion.
- Others:
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!