3D MODEL DESCRIPTION
A warm-hearted hatchling curled inside a cozy ember-lit shell, casting a gentle fiery glow without the heat.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 20 Hours 42 Minutes* (may vary according to you printer model)
Multipart - 21 Hours 01 Minute* (may vary according to you printer model)
Multicolor - 1 Day 1 Hour 48 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 19 cm
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: This files requires super glue. You will need a cable with a plug that is compatible with your region. You can weld the internal cables of the light. Always use LED light sources to avoid damaging your light fixture.
On this project you can choose between 3 types of light source:
G9 (you’ll need to print the g9 adapter) - Socket/Conector G9 - Amazon - AliExpress - Mercado Livre
LED Lamp G9 - Amazon - AliExpress - Mercado Livre
Tea Light Candle (dismantle the candle and use only the bottom part. The slot on the base is designed for a 3.4 mm diameter) -
Led Candle - Amazon Mercado Livre Aliexpress
Bambu LED Kit: Bambu Store Amazon Aliexpress
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) - EGG AND BASE
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.16 mm
- Recommended Layer Height: 0.16 mm
- Recommended Perimeters/ Walls: 2 walls
- Recommended Infill (%): 2% (Concentric) in the egg and 5% (gyroid) in the base
- Needs Support: No.
- Build Plate Adhesion: No.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) - DRAGON AND ADAPTER
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.16 mm
- Recommended Layer Height: 0.16 mm
- Recommended Perimeters/ Walls: 3 walls
- Recommended Infill (%): 3% (Grid)
- Needs Support: No.
- Build Plate Adhesion: Brim only on “Horns”.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!