Feline Match - Pendants

3D MODEL DESCRIPTION

Two cats, two halves, one perfect match. These pendants snap together just like the pair who always lands on their feet, preferably next to each other.

• This STL file is recommended for FDM Printers!
• 3D Printing Time : Monocolor - 01 Hour 28 Minutes*  (may vary according to you printer model)
                                Multicolor - 06 Hours 37 Minutes*  (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 04 colors)
• Approximately Height: 5 cm

*Note: Printing time based on a Bambu P1s printer, according to our tests.

Note: This model has a built-in magnet slot, and to insert it, a print pause must be scheduled at the corresponding layer.

Important: If your nozzle is metal, it may attract the magnet. A drop of super glue might be necessary.

You Will Need: 

Split Key Ring with Chain - AliExpress - Amazon - Mercado Livre

Ring Conector 8 mm - AliExpress - Amazon - Mercado Livre

2x Neodymium Magnets 6mm x 2mm - AliExpress - Amazon - Mercado Livre 

Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)

• Line Width/ Nozzle: 0.4 mm
• First Layer Line Width: 0.48 mm / 120%
• Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
• Recommended Initial Layer Height:  0.2 mm
• Recommended Layer Height:  0.2 mm
• Recommended Perimeters/ Walls: 3.
• Recommended Infill (%): 5% (Gyroid)
• Needs Support: No.
• Build Plate Adhesion: No.
• Others: Suggestion, use the initial layer with 0.42mm

The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.

Happy Printing!