3D MODEL DESCRIPTION
Your essential setup. Clean, simple, and ready for whatever the day throws at you.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 01 Day 5 Hours 05 Minutes* (may vary according to you printer model)
- Approximately measure: 85cm x 14cm x 12cm (assembled)
*Note: Printing time based on a Bambu P1s printer, according to our tests.
Attention: This piece has details with tight tolerances (where the filament fits), pay attention to the “seams” and position it so that it doesn't interfere with the fittings. For more information, check out the slicing video.
Note: The piece “Clips and Post it Holder” has a built-in magnet slot, and to insert it, a print pause must be scheduled at the corresponding layer. If your nozzle is metal, it may attract the magnet. A drop of super glue might be necessary.
You will need:
Silicone bumpers anti-slip (8mm x 2,5mm): Amazon Aliexpress Mercado Livre
Magnets (1x) size 12mm x 4mm.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: No.
- Enable the "Detect thin walls" option.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
