3D MODEL DESCRIPTION
Where shadow meets flame. A dragon guarding the edge between light and darkness.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Multipart - 01 Day, 03 Hours, 12 Minutes* (may vary according to you printer model)
Multicolor - 01 Day, 04 Hours, 26 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 25 cm (assembled files)
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: This files requires super glue. You will need a cable with a plug that is compatible with your region. You can weld the internal cables of the light or simply insulate them with electrical tape.
You Will Need: Socket/Conector G9 - Amazon - AliExpress - Mercado Livre
LED Lamp G9 - Amazon - AliExpress - Mercado Livre
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.16 mm
- Recommended Layer Height: 0.16 mm
- Others: We use (Archimedean Chords) for finishing the top layers.
- Recommended Perimeters/ Walls: 3 walls in almost parts, and 2 Wall only on “Moon” files.
- Recommended Infill (%): 10% (Gyroid) and you will need to use 1% (Concentric) infill only on light “Moon” file.
- Needs Support: Yes, (Tree Type).
- Build Plate Adhesion: Yes. (Brim) only in the smallest parts with low bed adhesion.
- Others: For small part use a 0.12 mm profile for better finishing.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.