Dino Hatch - Pen Clicker

3D MODEL DESCRIPTION
 

 Dinosaur hatchling toppers that click onto the top of a pen and beg to be pressed. Satisfying click, adorable disguise.

• This STL file is recommended for FDM Printers!
• 3D Printing Time: Monocolor Parasaur - 01 Hour, 14 Minutes* (may vary according to your printer model)                           
                              Multicolor Parasaur - 08 Hours, 36 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors)
  
                                Monocolor Pterosaur - 01 Hour, 14 Minutes* (may vary according to your printer model)                       
                                Multicolor Pterosaur - 08 Hours, 37 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors)
  
                                  Monocolor T-Rex - 01 Hour, 11 Minutes* (may vary according to your printer model)                            
                                  Multicolor T-Rex - 05 Hours, 33 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors)
  
                                  Monocolor Triceratops - 01 Hour, 01 Minutes* (may vary according to your printer model)                   
                                  Multicolor Triceratops - 09 Hours, 43 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors)
  
                                  Monocolor Eggshell - 01 Hour, 02 Minutes* (may vary according to your printer model)                      
                                  Multicolor Eggshell - 03 Hours, 02 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 02 colors)
• Approximately Height: 06 cm (Assembled Files)
   

*Note: Printing time based on a Bambu P1S printer, according to our tests.

 ATTENTION: This files require super glue.

You Will Need: Clicker Switch - 1x - Amazon - AliExpress - Mercado Livre

3D PRINT SETTINGS (FOR 0.4 MM NOZZLE)

• Line Width/ Nozzle: 0.4 mm
• First Layer Line Width: 0.48 mm / 120%
• Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
• Recommended Initial Layer Height:  0.12 mm
• Recommended Layer Height:  0.12 mm
• Recommended Perimeters/ Walls: 2.
• Recommended Infill (%): 5% (Gyroid)
• Needs Support: Yes, (Manual Snug) only “Dinos” files.
• Build Plate Adhesion: No.

 The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.

Happy Printing!