Coffin Break

3D MODEL DESCRIPTION
 

Even Death needs a coffee break before the soul collecting.

This STL file is recommended for FDM Printers!

• 3D Printing Time : Monocolor - 01 Hours, 15 Minutes*  (may vary according to you printer model)
                                Monocolor Keychain - 01 Hours, 15 Minutes*  (may vary according to you printer model)
  
                                Multipart - 01 Hours, 12 Minutes*  (may vary according to you printer model)
                                Multipart Keychain - 01 Hours, 14 Minutes*  (may vary according to you printer model)
  
                                Multicolor - 08 Hours, 49 Minutes*  (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors)
                                Multicolor Keychain - 08 Hours, 50 Minutes*  (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors)
• Approximately Measurements: 07 cm (Assembled Files)
  
   

*Note: Printing time based on a Bambu P1S printer, according to our tests.

You Will Need: Split Key Ring with Chain - AliExpress - Amazon - Mercado Livre
                          Ring Conector 12 mm - AliExpress - Amazon - Mercado Livre

*Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
 

ATTENTION: This files requires super glue. More information in the "How to" videos.

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)

• Line Width/ Nozzle: 0.4 mm
• First Layer Line Width: 0.48 mm / 120%
• Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
• Recommended Initial Layer Height:  0.16 mm
• Recommended Layer Height:  0.16 mm
• Others: We use (Archimedean Chords) for finishing the top layers, if you prefer.
• Recommended Perimeters/ Walls: 2.
• Recommended Infill (%): 10% (Grid)
• Needs Support: No.
• Build Plate Adhesion: Yes. (Brim) only in the smallest parts with low bed adhesion. 
• Others: For small parts, use a 0.08 mm profile for better finishing. 
  
   

The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.

Happy Printing!