Catbot

3D MODEL DESCRIPTION
 

Nine lives, infinite upgrades!

Liked what you see? This model was designed by @Atoy_3D
 

• This STL file is recommended for FDM Printers!
• 3D Printing Time Based on Ender 3:  1 Day 00 Hours  58 Minutes (will vary accord to you printer model)
• Approximately Height:  8,8 cm

Note: For whiskers, use a piece of filament (we used it in our models). Just cut a section of your 1.75mm filament to the length you prefer and insert it into the holes in the catbot's snout.

We do not recommend the use of SILK filaments for this piece. The piece contains fittings and joints, and the Silk filament does not have the necessary physical properties to ensure the required strength for the piece. The use of Silk-type filament is at your discretion. 
 

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
 

• Line Width/ Nozzle: 0.4 mm
• First Layer Line Width: 0.48 mm / 120%
• Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
• Recommended Initial Layer Height:  0.2 mm
• Recommended Layer Height:  0.2 mm
• Recommended Perimeters/ Walls: 3.
• Recommended Infill (%): 10% (Gyroid)
• Needs Support: Yes.
• Build Plate Adhesion: No.
   

The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.

Happy Printing!