3D MODEL DESCRIPTION
Bring a pop of mushroom magic to your fridge, locker, or office board. These adorable caps hold notes, photos, or reminders with charm and fun.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Multipart - 04 Hours 10 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 02 colors)
- Approximately Height: 17 x 08 x 06 cm (assembled files)
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: This files requires super glue.
You will need: 16x Neodymium Magnets (6 x 3 mm round) - Mercado Livre - Amazon - Aliexpress
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.12 mm
- Recommended Layer Height: 0.12 mm
- Others: We use (Archimedean Chords) for finishing the top layers.
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.*
- Build Plate Adhesion: Yes. (Brim) only in “Stem” files.
- Others: *If your 3D printer or slicing profile is not calibrated for bridge mode, use support (Grid) type.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!