3D MODEL DESCRIPTION
All smiles and gentle energy, this bunny brings a warm shine to any corner. Perfect for quiet moments, bedtime stories, and rooms that need a little extra cheer.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 04 Hours 31 Minutes* (may vary according to you printer model)
Multiparts - 05 Hours 35 Minute* (may vary according to you printer model) - Approximately Height: 16 cm
*Note: Printing time based on a Bambu P1S printer, according to our tests.
ATTENTION: This files requires super glue. You will need a cable with a plug that is compatible with your region. You can weld the internal cables of the light. Always use LED light sources to avoid damaging your light fixture.
On this project you can choose between 3 types of light source:
G9 (you’ll need to print the g9 adapter) - Socket/Conector G9 - Amazon - AliExpress - Mercado Livre
LED Lamp G9 - Amazon - AliExpress - Mercado Livre
Tea Light Candle (dismantle the candle and use only the bottom part. The slot on the base is designed for a 3.4 mm diameter) - Led Candle - Amazon Mercado Livre Aliexpress
Bambu LED Kit: Bambu Store Amazon Aliexpress
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) - BASE
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 2 walls
- Recommended Infill (%): 5% Gyroid
Needs Support: No. - Build Plate Adhesion: No.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) - LIGHT
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3 walls
- Recommended Infill (%): 0% (Grid)
- Needs Support: Yes (Tree)
- Wall Generator: Arachne.
- Infill/Wall Overlap: 0%
- Build Plate Adhesion: Brim.
****For better top layers use VARIABLE LAYER HEIGTH****
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
