3D MODEL DESCRIPTION
A cat that actually listens when you tap it? Miraculous.
Liked what you see? This model was designed by @valeriamomo_mattia3d
- This STL file is recommended for FDM Printers!
- 3D Printing Time Based on Ender 3: 07 Hours, 22 Minutes (will vary accord to you printer model)
- Approximately Length: 8 cm
Keyboard EPOMAKER Switch: Amazon *Recommended by Valeria & Mattia
Alternative Switch models: Aliexpress Amazon
Note: For whiskers, use a piece of filament (we used it in our models). Just cut a section of your 1.75mm filament to the length you prefer and insert it into the holes in the Bouncy Cat snout.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.12 mm
- Recommended Layer Height: 0.12 mm
- Recommended Perimeters/ Walls: 2.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: Yes.
- Build Plate Adhesion: Yes.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
