3D MODEL DESCRIPTION
A juicy, fruit-fresh charm with a sweet berry lipstick case, a colorful photocard, and a fruity clip that pops just as much as it protects.
- This STL file is recommended for FDM Printers!
- 3D Printing Time : Monocolor - 06 Hours 03 Minutes* (may vary according to you printer model)
Multicolor - 12 Hours 42 Minutes* (may vary according to you printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 15 cm
*Note: Printing time based on a Bambu P1s printer, according to our tests.
Attention: you can choose between two sizes. One to use with sleeve on your card and another to use without a sleeve.
You Will Need For the Keychains: Split Key Ring with Chain - AliExpress - Amazon - Mercado Livre
Ring Conector 12 mm - AliExpress - Amazon - Mercado Livre
Sleeve 87X56mm - Aliexpress - Amazon - Shopee
Neodymium Magnetic Size 6x2mm - AliExpress - Amazon - Mercado Livre
Note: These links are purchase suggestions, and are products similar to those we use in our development and testing. Variations may occur. Pay attention to the measurements indicated and/or assembly instructions to ensure correct fitting.
Note: the piece "Berry Bright Flower Keychain" and "Berry Bright Strawberry Keychain" supports layered color-changes
ATTENTION: “Multipart” files requires super glue.
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab)
- Recommended Initial Layer Height: 0.2 mm
- Recommended Layer Height: 0.2 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 5% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Brim (Only for small pieces).
- Others:
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
