3D MODEL DESCRIPTION
These Ankylosauruses were designed with a new innovative articulation inspired by the real dinosaurs. They’re also print-in-place, so there’s no need for supports. As an advanced model, these will demand some printing skill from you. Just slow down on the first layer, and you’ll be good to go.
If you’re still nervous about printing it, try the baby version first!
- This STL file is recommended for FDM Printers!
- 3D Printing Time: 21 Hours 51 Minutes
- Approximately length: 22,5 cm
- Remember to REMOVE SUPPORTS under the legs
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 15 mm/s (First Layer) / 45 mm/s (All the other layers)
- Recommended Initial Layer Height: 0.20 mm
- Recommended Layer Height: 0.20 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: None.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!